IPv4 Routing | 671
Example
Figure 24-18. show ip management route Command Example
show ipv6 management-route
c e
Display the IPv6 static routes configured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC Privilege
Command
History
Example
FTOS#show ipv6 management-route
IPv6 Destination Gateway State
---------------- ------- -----
2001:34::0/64 ManagementEthernet 0/0 Connected
2001:68::0/64 2001:34::16 Active
FTOS#
show ip protocols
c e s
View information on all routing protocols enabled and active on the switch.
Syntax
show ip protocols
Command Modes
EXEC
EXEC Privilege
Command
History
FTOS#show ip management-route
Destination Gateway State
----------- ------- -----
10.1.2.0/24 ManagementEthernet 0/0 Connected
172.16.1.0/24 10.1.2.4 Active
FTOS#
all Enter the keyword all to view all IP addresses assigned to all Management
interfaces on the switch.
connected Enter the keyword connected to view only routes directly connected to the
Management interface.
summary Enter the keyword summary to view a table listing the number of active and
non-active routes and their sources.
static Enter the keyword static to view non-active routes also.
Version 8.4.1.0 Introduced
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Regular evaluation optimization enabled/disabled added to display output
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
To Next Page
Loading...
