Dell Force10 TeraScale E Series - Page 678

678 | IPv4 Routing
www.dell.com | support.dell.com
Usage
Information
The F10 Monitoring MIB provides access to the statistics described below.
show protocol-termination-table
e
Display the IP Packet Termination Table (IPPTT).
Syntax
show protocol-termination-table linecard number port-set port-pipe-number
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
...no port broadcasts The incoming broadcast/multicast packet did not have any listener.
...socket full The applications buffer was full and the incoming packet had to be dropped.
Table 24-16. show ip traffic output definitions
Keyword Definition
Table 24-17. F10 Monitoring MIB
Command Display Object OIDs
IP statistics:
Bcast:
Received
Sent
f10BcastPktRecv
f10BcastPktSent
1.3.6.1.4.1.6027.3.3.5.1.1
1.3.6.1.4.1.6027.3.3.5.1.2
Mcast:
Received
Sent
f10McastPktRecv
f10McastPktSent
1.3.6.1.4.1.6027.3.3.5.1.3
1.3.6.1.4.1.6027.3.3.5.1.4
ARP statistics:
Rcvd:
Request
Replies
f10ArpReqRecv
f10ArpReplyRecv
1.3.6.1.4.1.6027.3.3.5.2.1
1.3.6.1.4.1.6027.3.3.5.2.3
Sent:
Request
Replies
Proxy
f10ArpReqSent
f10ArpReplySent
f10ArpProxySent
1.3.6.1.4.1.6027.3.3.5.2.2
1.3.6.1.4.1.6027.3.3.5.2.4
1.3.6.1.4.1.6027.3.3.5.2.5
linecard number Enter the keyword linecard followed by slot number of the line
card.
E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i,
and 0 to 5 on a E300
port-set port-pipe-number Enter the keyword port-set followed by the line card’s Port-Pipe
number.
Range: 0 to 1