Dell Force10 TeraScale E Series - Page 712

712 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
route-map
c e s
Designate a IPv6 route map name and enter the ROUTE-MAP mode.
Syntax
route-map map-name
To delete a route map, use the no route-map map-name command.
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
Example
Figure 25-9. Command Example: route-map
Related
Commands
set ipv6 next-hop
c e s
Configure a filter that specifies IPv6 address as the next hop.
Syntax
set ipv6 next-hop ipv6-address
To delete the setting, use the no set ipv6 next-hop ipv6-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
map-name
Enter a text string to name the route map, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced support on the E-Series TeraScale
FTOS(conf)#route-map Rmap1
FTOS(config-route-map)#match ?
…
ip IP specific information
ipv6 IPv6 specific information
…
show config View the current configuration.
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
Note: The
:: notation specifies successive hexadecimal fields of zeros