Dell Force10 TeraScale E Series - Page 730

730 | IPv6 Basics
www.dell.com | support.dell.com
Example
Figure 26-9. Command Example: show ipv6 route summary
Table 26-1. show ipv6 route Command Example Fields
Field Description
(undefined) Identifies the type of route:
• L = Local
• C = connected
•
S = static
•
R = RIP
•
B = BGP
•
IN = internal BGP
•
EX = external BGP
•
LO = Locally Originated
•
O = OSPF
•
IA = OSPF inter area
•
N1 = OSPF NSSA external type 1
•
N2 = OSPF NSSA external type 2
•
E1 = OSPF external type 1
•
E2 = OSPF external type 2
•
i = IS-IS
•
L1 = IS-IS level-1
•
L2 = IS-IS level-2
•
IA = IS-IS inter-area
•
* = candidate default
•
> = non-active route
• + = summary routes
Destination Identifies the route’s destination IPv6 address.
Gateway Identifies whether the route is directly connected and on which interface the route is
configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
FTOS#show ipv6 route summary
Route Source Active Routes Non-active Routes
connected 5 0
static 0 0
Total 5 0
Total 5 active route(s) using 952 bytes