Dell Force10 TeraScale E Series - Page 760

760 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Syntax
maximum-paths {ebgp | ibgp} number
To return to the default values, enter no maximum-paths.
Parameters
Defaults
1
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
If you enable this command, use the capture bgp-pdu max-buffer-size command to recompute the best
path.
neighbor activate
c e
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.
Syntax
neighbor {ipv6-address | peer-group-name} activate
To disable, use the no neighbor {ipv6-address | peer-group-name} activate command.
Parameters
Defaults
Disabled
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
By default, when a neighbor/peer group configuration is created in the Router BGP context, it is
enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context, the neighbor/peer
group is enabled for AFI/SAFI.
ebgp Enter the keyword ebgp to enable multipath support for External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for Internal BGP routes.
number
Enter a number as the maximum number of parallel paths.
Range: 1 to 16
Default: 1
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
Identify a peer group by name.
activate Enter the keyword activate to enable the identified neighbor or peer
group in the new AFI/SAFI.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale