Dell Force10 TeraScale E Series - Page 780

780 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
When you enter redistribute ospf process-id command without any other parameters, FTOS
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
router bgp
c e
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
show capture bgp-pdu neighbor
c e
Display BGP packet capture information for an IPv6 address on the E-Series.
Syntax
show capture bgp-pdu neighbor ipv6-address
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
as-number
Enter the AS number.
Range: 1 to 65535.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
Enter the IPv6 address (X:X:X:X::X) of a BGP neighbor.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale