Dell Force10 TeraScale E Series - Page 785

IPv6 Border Gateway Protocol (IPv6 BGP) | 785
Command Modes
EXEC
EXEC Privilege
Command
History
show ip bgp ipv6 unicast flap-statistics
c e
View flap statistics on BGP routes.
Syntax
show ip bgp ipv6 unicast flap-statistics [ipv6-address prefix-length] [filter-list
as-path-name] [regexp regular-expression]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
show ip bgp ipv6 unicast inconsistent-as
c e
View routes with inconsistent originating Autonomous System (AS) numbers, that is, prefixes that are
announced from the same neighbor AS but with a different AS-Path.
Syntax
show ip bgp ipv6 unicast inconsistent-as
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
filter-list as-path-name (OPTIONAL) Enter the keyword filter-list followed by the name of
a configured AS-PATH ACL.
regexp regular-expression
Enter a regular expression then use one or a combination of the
following characters to match:
• . = (period) any single character (including a white space)
•
* = (asterisk) the sequences in a pattern (0 or more sequences)
• + = (plus) the sequences in a pattern (1 or more sequences)
• ? = (question mark) sequences in a pattern (either 0 or 1
sequences). You must enter an escape sequence (CTRL+v)
prior to entering the ? regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ^ = (caret) the beginning of the input string. If the caret is used at
the beginning of a sequence or range, it matches on everything
BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale