Dell Force10 TeraScale E Series - Page 790

790 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
show ip bgp ipv6 unicast peer-group
c e
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp ipv6 unicast peer-group [peer-group-name [summary]]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 27-3. show ip bgp peer-group Command Example
peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
detail (OPTIONAL) Enter the keyword detail to view peer-group-specific information
for the IPv6 address family.
summary (OPTIONAL) Enter the keyword summary to view status information of the
peers in that peer group.
The output is the same as that found in show ip bgp ipv6 unicast summary
command
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
FTOS#show ip bgp peer-group
Peer-group RR-CLIENT, remote AS 18508
BGP version 4
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP neighbor is RR-CLIENT, peer-group internal,
Number of peers in this group 1
Peer-group members (* - outbound optimized):
9000::4:
Peer-group RR-CLIENT-PASSIV, remote AS 18508
BGP version 4
Minimum time between advertisement runs is 5 seconds
For address family: IPv4 Unicast
BGP neighbor is RR-CLIENT-PASSIV, peer-group internal,
Number of peers in this group 1
Peer-group members (* - outbound optimized):
9000::9:2*
FTOS#