Dell Force10 TeraScale E Series - Page 796

796 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
To remove SAFI context, use the no address family ipv6 unicast command.
Parameters
Defaults
IPv6 Unicast
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
All subsequent commands will apply to this address family once this command is executed. You can
exit from this AFI/SAFI to the IPv6 Unicast (the default) family by entering exit and returning to the
Router BGP context.
aggregate-address
c e
Summarize a range of prefixes to minimize the number of entries in the routing table.
Syntax
aggregate-address ipv6-address prefix-length [advertise-map map-name] [as-set]
[attribute-map map-name] [summary-only] [suppress-map map-name]
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
ipv6 Enter the keyword ipv6 to specify the address family as IPv6.
unicast Enter the keyword unicast to specify multicast as SAFI.
Version 8.4.2.1 Introduced on C-Series and S4810.
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address prefix-length Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the
/x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zeros.
advertise-map
map-name
(OPTIONAL) Enter the keywords advertise-map followed by the
name of a configured route map to set filters for advertising an aggregate
route.
as-set (OPTIONAL) Enter the keyword as-set to generate path attribute
information and include it in the aggregate.
AS_SET includes AS_PATH and community information from the routes
included in the aggregated route.
attribute-map map-name (OPTIONAL) Enter the keywords attribute-map followed by the name
of a configured route map to modify attributes of the aggregate, excluding
AS_PATH and NEXT_HOP attributes.
summary-only (OPTIONAL) Enter the keyword summary-only to advertise only the
aggregate address. Specific routes will not be advertised.
suppress-map
map-name
(OPTIONAL) Enter the keywords suppress-map followed by the
name of a configured route map to identify which more-specific routes in
the aggregate are suppressed.