Link Aggregation Control Protocol (LACP) | 863
lacp long-timeout
c e
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command.
Defaults
1 second
Command Modes
INTERFACE (conf-if-po-number)
Command
History
Usage
Information
This command applies to dynamic port-channel interfaces only. When applied on a static port-channel,
the command has no effect.
Related
Commands
lacp port-priority
c e s
Configure the port priority to influence which ports will be put in standby mode when there is a
hardware limitation that prevents all compatible ports from aggregating.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
Defaults
32768
Command Modes
INTERFACE
Command
History
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 7.5.1.0 Introduced on E-Series
show lacp Display the lacp configuration
priority-value
Enter the port-priority value. The higher the value number the lower the priority.
Range: 1 to 65535
Default: 32768
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series
To Next Page
Loading...
