Dell Force10 TeraScale E Series - Page 888

888 | Layer 2
www.dell.com | support.dell.com
default vlan-id
c e s
Specify a VLAN as the Default VLAN.
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no default
vlan-id vlan-id syntax.
Parameters
Defaults
The Default VLAN is VLAN 1.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-id 1).
The Default VLAN contains only untagged interfaces.
Related
Commands
default-vlan disable
c e s
Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly
configured as a member of another VLAN.
Defaults
The default VLAN is enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
no default vlan disable is not listed in the running-configuration, but when the default VLAN is
disabled, default-vlan disable is listed in the running-configuration.
enable vlan-counters
e
x
Display VLAN counters for ingress and/or egress hardware. You must be in restricted mode to use this
command.
Syntax
enable vlan-output-counters [ingress | egress | all]
To return to the default (disabled), use the no enable vlan-output-counters command.
vlan-id
Enter the VLAN ID number of the VLAN to become the new Default VLAN.
Range: 1 to 4094.
Default: 1
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
Version 8.3.1.0 Introduced