890 | Layer 2
www.dell.com | support.dell.com
name
c e s
Assign a name to the VLAN.
Syntax
name vlan-name
To remove the name from the VLAN, enter no name.
Parameters
Defaults
Not configured.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
To display information about a named VLAN, enter the show vlan command with the name parameter
or the show interfaces description command.
Related
Commands
show config
c e s
Display the current configuration of the selected VLAN.
Syntax
show config
Command Modes
INTERFACE VLAN
Example
Figure 30-10. show config Command Sample Output for a Selected VLAN
Command
History
vlan-name
Enter up to 32 characters as the name of the VLAN.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
description Assign a descriptive text string to the interface.
interface vlan Configure a VLAN.
show vlan Display the current VLAN configurations on the switch.
FTOS(conf-if-vl-100)#show config
!
interface Vlan 100
no ip address
no shutdown
FTOS(conf-if-vl-100)#
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
To Next Page
Loading...
