Dell Force10 TeraScale E Series - Page 900

900 | Link Layer Detection Protocol (LLDP)
www.dell.com | support.dell.com
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
clear lldp neighbors
c e s
Clear LLDP neighbor information for all interfaces or a specific interfaces.
Syntax
clear lldp neighbors {interface}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
debug lldp interface
c e s
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other
information about incoming and outgoing packets.
Syntax
debug lldp interface {interface | all}{events| packet {brief | detail} {tx | rx | both}}
To disable debugging, use the no debug lldp interface {interface | all}{events} {packet {brief
| detail} {tx | rx | both}} command.
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series