Dell Force10 TeraScale E Series - Page 903

Link Layer Detection Protocol (LLDP) | 903
multiplier
c e s
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
Defaults
4 x hello
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
protocol lldp (Configuration)
c e s
Enable LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults
Disabled
Command Modes
CONFIGURATION (conf-lldp)
Command
History
protocol lldp (Interface)
c e s
Enter the LLDP protocol in the INTERFACE mode.
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command from the
Interface mode.
Defaults
LLDP is not enabled on the interface.
Command Modes
INTERFACE (conf-if-interface-lldp)
Command
History
integer
Enter the number of consecutive misses before the LLDP declares the interface dead.
Range: 2 - 10
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
Version 7.7.1.0 Introduced on S-Series