Dell Force10 TeraScale E Series - Page 919

Multicast Listener Discovery (MLD) | 919
ipv6 mld static-group
e
Configure an MLD static group to exclude or include mode.
Syntax
ipv6 mld static-group group-address {exclude [source-address] | include source-address}
To return to default, use the no ipv6 mld static-group group-address {exclude
[source-address] | include source-address} command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if)
Command
History
ipv6 mld version
e
Set the MLD version number on this interface.
Syntax
ipv6 mld version 1
Defaults
Version 2
Command Modes
INTERFACE (conf-if)
Command
History
Usage
Information
FTOS supports MLD version 2 and is backward compatible with MLD version 1.
Command
History
show ipv6 mld groups
e
View the configured MDL groups.
Syntax
show ipv6 mld groups [detail] [explicit] [link-local] [group-address] [interface interface
[detail]] [summary]
group-address (OPTIONAL) Enter the multicast group address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zero.
exclude
source-address
Enter the keyword exclude and optionally enter the source ip address in the
x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zero.
include
source-address
Enter the keyword include followed by source ip address in the x:x:x:x::x
format.
The
:: notation specifies successive hexadecimal fields of zero.
Version 7.4.1.0 Introduced
Version 7.4.1.0 Introduced
Version 7.4.1.0 Introduced