Dell Force10 TeraScale E Series - Page 939

Multiple Spanning Tree Protocol (MSTP) | 939
description
c e s
Enter a description of the Multiple Spanning Tree
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE (The prompt is “config-mstp”.)
Command
History
Related
Commands
disable
c e s
Globally disable Multiple Spanning Tree Protocol on the switch.
Syntax
disable
To enable Multiple Spanning Tree Protocol, enter no disable.
Defaults
Multiple Spanning Tree Protocol is disabled
Command Modes
MULTIPLE SPANNING TREE
Command
History
Related
Commands
description
Enter a description to identify the Multiple Spanning Tree (80 characters maximum).
pre-7.7.1.0 Introduced
protocol spanning-tree mstp Enter Multiple SPANNING TREE mode on the switch.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 6.5.1.0 Introduced
protocol spanning-tree mstp Enter MULTIPLE SPANNING TREE mode.