Dell Force10 TeraScale E Series - Page 972

972 | Multicast
www.dell.com | support.dell.com
show ipv6 mroute
e
View IPv6 multicast routes.
Syntax
show ipv6 mroute [group-address [source-address]] [active rate] [count group-address
[source source-address]]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 35-9. show ipv6 mroute command Example
group-address
[
source-address]
(OPTIONAL) Enter the IPv6 multicast group-address to view only
routes associated with that group. Optionally, enter the IPv6
source-address to view routes with that group-address and
source-address.
active [rate] (OPTIONAL) Enter the keyword active to view active multicast
sources. Enter a rate to view active routes over the specified rate.
Range: 0 to 10000000 packets/second
count
group-address
[
source source-address]}
(OPTIONAL) Enter the keyword count to view the number of IPv6
multicast routes and packets on the E-Series. Optionally, enter the IPv6
source-address count information.
Version 7.4.1.0 Introduced
FTOS#show ipv6 mroute
IP Multicast Routing Table
(165:87:32::30, ff05:100::1), uptime 00:01:11
Incoming interface: Vlan 200
Outgoing interface list:
GigabitEthernet 2/14
(165:87:37::30, ff05:200::1), uptime 00:01:04
Incoming interface: Port-channel 200
Outgoing interface list:
Vlan 200
(165:87:31::30, ff05:300::1), uptime 00:01:19
Incoming interface: GigabitEthernet 2/14
Outgoing interface list:
Port-channel 200
(165:87:32::30, ff05:1100::1), uptime 00:01:08
Incoming interface: Vlan 200
Outgoing interface list:
GigabitEthernet 2/14
(165:87:37::30, ff05:2200::1), uptime 00:01:01
Incoming interface: Port-channel 200
Outgoing interface list:
Vlan 200
FTOS#