Dell Force10 TeraScale E Series - Page 974

974 | Multicast
www.dell.com | support.dell.com
show ipv6 mroute mld
e
Display the Multicast MLD information.
Syntax
show ipv6 mroute [mld [group-address | all | vlan vlan-id]]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 35-13. show ipv6 mroute mld all Command Example
mld
(OPTIONAL) Enter the keyword mld to display Multicast MLD
information.
group-address
(OPTIONAL) Enter the multicast group address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zero.
all
(OPTIONAL) Enter the keyword all to view all the MLD information.
vlan vlan-id
(OPTIONAL) Enter the keyword vlan followed by the VLAN ID to view
MLD VLAN information.
Version 7.4.1.0 Introduced
FTOS#show ipv6 mroute mld all
MLD SNOOPING MRTM Table
(*, ff05:100::1), uptime 00:04:21
Incoming vlan: Vlan 200
Outgoing interface list:
GigabitEthernet 2/15
GigabitEthernet 2/16
(*, ff05:200::1), uptime 00:04:15
Incoming vlan: Vlan 200
Outgoing interface list:
GigabitEthernet 2/15
GigabitEthernet 2/16
(*, ff05:1100::1), uptime 00:04:18
Incoming vlan: Vlan 200
Outgoing interface list:
GigabitEthernet 2/15
GigabitEthernet 2/16
FTOS#