Figure 31. Configuration 3: -8 x 2.5 inch SAS/SATA and fPERC card with optional BOSS N1
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 59. Connector descriptions for 8 x 2.5 inch SAS/SATA and fPERC card with optional BOSS N1
Order From To
1 J_SLOT1 (fPERC Riser) CTRL_DST_PA1 (fPERC connector)
2 PIB (system board connector) PIB_SIG_1 (PIB signal connector)
3 P1 (system board power connector) SYS (PIB power connector)
4 P2 (system board power connector) CPU (PIB power connector)
5 SIG_PWR_1(PIB power connector) BP_PWR_1 (backplane power
connector)
6 SL2_PCH_PA2 (system board signal
connector)
J_PCIE_1 (BOSS N1 signal connector)
7 MB_BOSS_PWR (System board power
connector)
J_PWR_1 (BOSS N1 power connector)
Installing and removing system components 65
To Next Page
Loading...
