Dell PowerEdge R6615 9JNDF - Page 98

Figure 69. Configuration 3-1: 8 x 2.5-inch NVMe
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 71. 8 x 2.5-inch NVMe
Order From To
1 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
2 SL1 (signal connector on system board) BP_DST_PA1 (backplane signal connector)
3 SL3 (signal connector on system board) BP_DST_PB1 (backplane signal connector)
4 SL7 (signal connector on system board) BP_DST_PA2 (backplane signal connector)
5 SL8 (signal connector on system board) BP_DST_PB2 (backplane signal connector)
98 Installing and removing system components