Script Commands 119
Parameters
NOTE: The starting logical block address and the ending logical block address are
useful for very large single-virtual disk LUNs. Running a virtual disk consistency
check on a very large single-virtual disk LUN can take a long time. By defining the
beginning address and ending address of the data blocks, you can reduce the time
that a virtual disk consistency check takes to complete.
Parameter Description
virtualDisk Name of the specific virtual disk to check
consistency. You must put brackets ([ ]) around the
virtual disk name. If the virtual disk name has
special characters, you must also put quotation
marks (" ") around the virtual disk name.
consistencyErrorFile Name of the file in which to save the consistency
error information. You must put quotation marks
(" ") around the file name.
mediaErrorFile Name of the file in which to save the media error
information. You must put quotation marks (" ")
around the file name.
priority Specifies the priority that the consistency check
has relative to host I/O activity. Valid entries are
highest, high, medium, low, or lowest.
startingLBA The starting logical block address. Use integer
values.
endingLBA The ending logical block address. Use integer
values.
verbose Captures progress details, such as percent
complete, and shows the information while virtual
disk consistency is being repaired. To capture
progress details, set this parameter to TRUE. To
prevent capturing progress details, set this
parameter to FALSE.
book.book Page 119 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
