Dell PowerVault MD3220 - Set Host Group; Set Host Port

194 Script Commands
Set Host Group
This command renames a host group.
Syntax
set hostGroup [hostGroupName]
userLabel="newHostGroupName"
Parameters
NOTE: You can use any combination of alphanumeric characters, hyphens, and
underscores for the names. Command names can have a maximum of 30
characters. If you exceed the maximum character limit, replace square brackets
([ ]) with angle brackets (< >) to overcome this limitation.
Set Host Port
This command changes the host type for an HBA host port. You can also
change an HBA host port label with this command.
Syntax
set hostPort [portLabel] host=“hostName”
userLabel=“newPortLabel”
Parameter Description
hostGroup Name of the host group to rename. You must put
brackets ([ ]) around the host group name. If the
host group name has special characters, you must
also put quotation marks (" ") around the host
group name.
userLabel New name for the host group. You must put
quotation marks (" ") around the host group
name.
book.book Page 194 Friday, March 4, 2011 10:45 AM