Dell PowerVault MD3220 - RAID Controller Module

Script Commands 197
Set iSCSI Target Properties
This command defines properties for an iSCSI target.
Syntax
set iscsiTarget [“iscsiID”]
authenticationMethod=(none | chap) |
chapSecret=”securityKey” |
targetAlias=”userLabel”
Parameters
NOTE: Challenge Handshake Authentication Protocol (CHAP) is a protocol that
authenticates the peer of a connection. CHAP is based upon the peers sharing a
“secret.” A secret is a security key that is similar to a password.
NOTE: Use the chapSecret parameter only for initiators requiring mutual
authentication.
NOTE: The targetAlias is a descriptive name that you can give to the target to help
make it easier to identify. You can use any combination of alphanumeric characters,
hyphens, and underscores for the
targetAlias . The targetAlias can have a maximum
of 30 characters.
Parameter Description
iSCSIID The iSCSI target for which you want to
set properties. Enclose the name in
double quotation marks (“ ”). You must
also enclose the iscsiID in either square
brackets ([ }») or angle brackets (< >).
authenticationMethod The means of authenticating your iSCSI
session.
chapSecret The password that you want to use to
authenticate a peer connection.
targetAlias The name that you want to use for the
target.
book.book Page 197 Friday, March 4, 2011 10:45 AM