Dell PowerVault MD3220 - Set Physical Disk State

Script Commands 199
Parameters
Set Physical Disk State
This command sets a physical disk to the Failed state. (To return a physical
disk to the optimal state, use the revive physicalDisk command.)
Syntax
set (physicalDisk [enclosureID,slotID] |
physicalDisks [enclosureID1,slotID1 enclosureID2,
slotID2 ... enclosureIDn,slotIDn])
operationalState=failed
Parameter
Parameter Description
physicalDisk or
physicalDisks
The tray and the slot where the physical disk
resides. Tray ID values are 0 to 99. Slot ID values
are 0 to 31. Enclose the tray ID values and the
slot ID values in square brackets ([ ]).
hotSpare The setting to assign the physical disk as the hot
spare. To assign the physical disk as the hot spare,
set this parameter to TRUE. To remove a hot
spare assignment from a physical disk, set this
parameter to FALSE.
Parameter Description
physicalDisk or
physicalDisks
The tray and the slot where the physical disk
resides. Tray ID values are 0 to 99. Slot ID values
are 0 to 31. Enclose the tray ID values and the
slot ID values in square brackets ([ ]).
book.book Page 199 Friday, March 4, 2011 10:45 AM