Dell PowerVault MD3220 - Troubleshooting: Your Storage Array Software; Device Health Conditions

Script Commands 217
Set Storage Array Time
This command sets the clocks on both RAID controller modules in a storage
array by synchronizing the RAID controller module clocks with the clock of
the host from which you run this command.
Syntax
set storageArray time
Parameters
None.
Set Storage Array Unnamed Discovery Session
This command enables the storage array to participate in unnamed discovery
sessions.
Syntax
set storageArray unnamedDiscoverySession=(TRUE |
FALSE)
Parameter
NOTE: Discovery is the process where initiators determine the targets that are
available. Discovery occurs at power-on/initialization and also if the bus topology
changes, for example, if an extra device is added.
NOTE: An unnamed discovery session is a discovery session that is established
without specifying a target ID in the login request. For unnamed discovery sessions,
neither the target ID nor the target portal group ID are available to the targets.
Parameter Description
unnamedDiscoverySession This parameter turns on or turns off unnamed
discovery sessions. Set the parameter to TRUE to
turn on unnamed discovery sessions. Set the
parameter to FALSE to turn off unnamed
discovery sessions.
book.book Page 217 Friday, March 4, 2011 10:45 AM