168 Script Commands
Recover RAID Virtual Disk
This command creates a RAID virtual disk with the given properties without
initializing any of the user data areas on the disks. Parameter values are derived
from the Recovery Profile data file for the storage array.
NOTE: This command can be run only from the command line. The storage
management GUI cannot be used to recover a virtual disk.
Syntax
recover virtualDisk (physicalDisk=
(enclosureID,slotID) |
physicalDisks=(enclosureID1,slotID1 enclosureID2,
slotID2 ... enclosureIDn, slotIDn) |
diskGroup=diskGroupName))
[newDiskGroup=diskGroupName]
userLabel=(”virtualDiskName”
virtualDiskWWID=”virtualDiskWWID”)
capacity=virtualDiskCapacity
offset=offsetValue
raidLevel=(0 | 1 | 5 | 6)
segmentSize=segmentSizeValue
dssPreallocate=(TRUE | FALSE)
SSID=virtualDiskCapacity
[owner=(0 | 1)
cacheReadPrefetch=(TRUE | FALSE)]
Parameters
Parameter Description
physicalDisk or
physicalDisks
Specifies the physical disks to assign to the virtual disk
that you want to create. Specify the tray ID and slot ID
for each physical disk that you assign to the virtual
disk. Tray ID values are 0 to 99. Slot ID values are 0
to 31. You must put brackets ([ ]) around the tray ID
value and the slot ID value.
book.book Page 168 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
