Dell PowerVault MD3220 - Show RAID Controller Module NVSRAM

232 Script Commands
Parameters
Show RAID Controller Module NVSRAM
This command returns a list of the NVSRAM byte values for the specified
host type. If you do not enter the optional parameters, this command returns
a list of all NVSRAM byte values.
Syntax
show (allControllers | controller [(0 | 1)])
NVSRAM [hostType=(hostTypeIndexLabel | host=
"hostName")]
Parameter Description
allControllers Returns information about both RAID controller modules in the
storage array.
controller Returns information about a specific RAID controller module in
the storage array. Valid RAID controller module identifiers are 0
or 1, where, 0 is the RAID controller module on the left and 1 is
the RAID controller module on the right when viewed from the
rear of the enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
summary Returns a concise list of information about both RAID
controller modules in the storage array.
book.book Page 232 Friday, March 4, 2011 10:45 AM