Dell PowerVault MD3220 - Start Disk Group Blink; Start Disk Group Defragment

Script Commands 247
In addition, the database configuration diagnostic test can be started using
the storage management software GUI but cannot be stopped using the
storage management software GUI. If you want to stop a running diagnostic
test, you must use the stop storageArray configDbDiagnostic
command.
Start Disk Group Blink
This command identifies the physical disks that are logically grouped
together to form the specified disk group by blinking the indicator LEDs on
the physical disks. (Use the stop diskGroup blink command to turn off the
indicator LEDs on the physical disks.)
Syntax
start diskGroup [diskGroupNumber] blink
Parameter
Start Disk Group Defragment
This command starts a defragment operation on the specified disk group.
NOTE: Defragmenting a disk group starts a long-running operation that you cannot
stop.
Syntax
start diskGroup [diskGroupNumber] defragment
Parameter
Parameter Description
diskGroup Number of the disk group to identify. You must
put brackets ([ ]) around the disk group number.
Parameter Description
diskGroup Number of the disk group to defragment. You
must put brackets ([ ]) around the disk group
number.
book.book Page 247 Friday, March 4, 2011 10:45 AM