Dell PowerVault MD3220 - Clear Storage Array Event Log; Clear Storage Array Firmware Pending Area

Script Commands 121
NOTE: When you run this command, the storage array becomes unresponsive, and
all script processing is cancelled. You must remove and re-add the storage array to
resume communication with the host. To remove an unresponsive storage array,
access the Enterprise Management Window, and click Edit Remove. To re-add
the storage array, access the Enterprise Management Window, click Edit  Add
Storage Array, and enter the appropriate IP addresses.
Clear Storage Array Event Log
This command clears the Major Event Log (MEL) for the storage array by
deleting the data in the MEL buffer.
CAUTION: As soon as you run this command, the existing MEL in the storage
array is deleted.
Syntax
clear storageArray eventLog
Parameters
None.
Clear Storage Array Firmware Pending Area
This command deletes a previously downloaded firmware image or
nonvolatile static random access memory (NVSRAM) values from the
pending area buffer.
CAUTION: As soon as you run this command, the contents of the existing pending
area in the storage array are deleted.
Syntax
clear storageArray firmwarePendingArea
Parameters
None.
volumeGroups The setting to remove the virtual disk
configuration and the disk group configuration.
The rest of the configuration stays intact.
Parameter Description
book.book Page 121 Friday, March 4, 2011 10:45 AM