Script Commands 145
physicalDiskType The type of physical disks that you want
to use for the snapshot repository virtual
disk. The valid physical disk type is SAS.
You must specify a physical disk type. Use
this parameter only when you use the
repositoryDriveCount parameter.
freeCapacityArea The index number of the free space in an
existing disk group to use to create the
snapshot repository virtual disk. Free
capacity is defined as the free capacity
between existing virtual disks in a disk
group. For example, a disk group might
have the following areas: virtual disk 1,
free capacity, virtual disk 2, free capacity,
virtual disk 3, free capacity. To use the free
capacity following virtual disk 2, you specify:
freeCapacityArea=2
Use the show diskGroup command to
determine if free capacity area exists.
NOTE: If you do not specify the
unconfigured or free space, the repository
virtual disk is placed in the same disk group
as the source virtual disk. If the disk group
where the source virtual disk resides does
not have enough space, this command fails.
warningThresholdPercent The percentage of repository capacity at
which you receive a warning that the
repository is nearing full. Use integer
values. For example, a value of 70 means
70 percent. The default value is 50.
Parameter Description
book.book Page 145 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
