Script Commands 159
Parameters
Parameter Description
enclosure Identifies the enclosure to which to load
new firmware. Enclosure ID values are 0
to 99. You must put brackets ([ ]) around
the enclosure ID value.
You can use the following parameters:
•The
allEnclosures
parameter, which
downloads new firmware to all of the
EMMs in the storage array
•The
enclosure
parameter, which
downloads new firmware to a specific
EMM. If you need to download new
firmware to more than one EMM, but
not all RAID controller modules, you
must enter this command for each
storage array.
file File path and file name of the file that
contains the firmware image. You must
put quotation marks (" ") around the
firmware image file path and file name.
book.book Page 159 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
