208 Script Commands
autoSupportConfig The setting for automatically collecting support
data each time the firmware detects a critical
MEL event. This parameter has these values:
• enable—Turns on the collection of support data
• disable—Turns off the collection of support
data
cacheBlockSize The cache block size that is used by the RAID
controller module for managing the cache. Valid
values are 4 (4 KB), 8 (8 KB), 16 (16 KB), or 32
(32 KB).
cacheFlushStart The percentage of unwritten data in the cache
that causes a cache flush. Use integer values from
0 to 100 to define the percentage. The default
value is 80.
cacheFlushStop The percentage of unwritten data in the cache
that stops a cache flush in progress. Use integer
values from 0 to 100 to define the percentage.
This value must be less than the value of the
cacheFlushStart parameter.
defaultHostType The default host type of any unconfigured host
port to which the RAID controller modules are
connected. To generate a list of valid host types
for the storage array, run the show storageArray
hostTypeTable command. Host types are
identified by a name or a numerical index.
Enclose the host type name in double quotation
marks (“ ”). Do not enclose the host type
numerical identifier in double quotation marks.
failoverAlertDelay The failover alert delay time in minutes. The
valid values for the delay time are 0 to 60
minutes. The default value is 5.
mediaScanRate The number of days over which the media scan
runs. Valid values are disabled, which turns off
the media scan, or 1 day to 30 days, where 1 day is
the fastest scan rate, and 30 days is the slowest
scan rate. A value other than disabled or 1 to 30
does not allow the media scan to function.
Parameter Description
book.book Page 208 Friday, March 4, 2011 10:45 AM
To Next Page
Loading...
