Chapter 7 Servo Parameters ASDA-B2
7-20 Revision September 2013
Display
Format:
Hexadecimal
Settings:
This parameter is used to display the digital output signal of the servo drive. The servo
output status display will show in hexadecimal format.
Bit0: SRDY (Servo ready)
Bit1: SON (Servo On)
Bit2: ZSPD (At Zero speed)
Bit3: TSPD (At Speed reached)
Bit4: TPOS (At Positioning completed)
Bit5: TQL (At Torque limit)
Bit6: ALRM (Servo alarm activated)
Bit7: BRKR (Electromagnetic brake control)
Bit9: OLW (Output overload warning)
Bit10: WARN (Servo warning activated. WARN is activated when the drive has
detected reverse limit error; forward limit error, emergency stop, serial
communication error, and undervoltage these fault conditions.)
Bit11: Reserved
Bit12: Reserved
Bit13: Reserved
Bit14: Reserved
Bit15: Reserved
The servo output status display can be monitored through communication also.
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
To Next Page
Loading...
