Delta Electronics ASDA-B2 series User Manual

Chapter 7 Servo Parameters ASDA-B2
7-2 Revision September 2013
7.2 Parameters Summary
Monitor and General Use
Parameter Name Function Default Unit
Control Mode
Related
Section
PT S T
P0-00★
VER Firmware Version
Factory
Setting
N/A O O O -
P0-01 ALE Drive Fault Code N/A N/A O O O
11.1
11.2
11.3
P0-02 STS
Drive Status (Front Panel
Display)
00 N/A O O O 7.2
P0-03 MON Analog Monitor Output 01 N/A O O O 4.3.5
P0-08★
TSON Servo Startup Time 0 Hour -
P0-09★
CM1 Status Monitor 1 N/A N/A O O O 4.3.5
P0-10★
CM2 Status Monitor 2 N/A N/A O O O 4.3.5
P0-11★
CM3 Status Monitor 3 N/A N/A O O O 4.3.5
P0-12★
CM4 Status Monitor 4 N/A N/A O O O 4.3.5
P0-13★
CM5 Status Monitor 5 N/A N/A O O O 4.3.5
P0-17 CM1A Status Monitor Selection 1 0 N/A -
P0-18 CM2A Status Monitor Selection 2 0 N/A -
P0-19 CM3A Status Monitor Selection 3 0 N/A -
P0-20 CM4A Status Monitor Selection 4 0 N/A -
P0-21 CM5A Status Monitor Selection 5 0 N/A -
P0-46★
SVSTS Servo Output Status Display 0 N/A O O O -
P1-04 MON1
Analog Monitor Output
Proportion 1 (MON1)
100
%(full
scale)
O O O 6.4.4
P1-05 MON2
Analog Monitor Output
Proportion 2 (MON2)
100
%(full
scale)
O O O 6.4.4
Explanation of symbols (marked after parameter)
(★) Read-only register.
(▲) Parameter cannot be set when Servo On (when the servo drive is enabled).
() Parameter is effective only after the servo drive is restarted (after switching power off and
on).
() Parameter setting values are not retained when power is off.
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.

Delta Electronics ASDA-B2 series Specifications

General

Brand	Delta Electronics
Model	ASDA-B2 series
Category	Servo Drives
Language	English