Chapter 7 Servo Parameters ASDA-B2
7-22 Revision September 2013
Pleae note:
1.
If an input pulse of 2~4MHz is used, it is recommended to change the setting value B (Input pulse
filter) and set this setting value to 4. Please note that this function is available for DSP version
V1.005 sub10 or above.
Note: If the signal is a 4Mpps high input pulse, setting the value B to 4 is able to ensure that the
signal will not be filtered and will be certainly delivered.
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
To Next Page
Loading...
