Delta Electronics ASDA-B2 series - Page 198

ASDA-B2 Chapter 7 Servo Parameters
Revision September 2013 7-33
Control
Mode:
PT
Unit: 0.1Hz
Range: 10 ~ 1000
Data Size: 16bit
Display
Format:
DEC
Example 150=15Hz
Settings: The setting value of the second low-frequency vibration suppression. If
P1-28 is set to 0, then it will disable the second low-frequency filter.
P1-28 VSG2
Low-frequency Vibration Suppression Gain
(2)
Address: 0138H
0139H
Operation
Interface:
Keypad/Software Communication
Related Section:
Section 6.2.9
Default: 0
Control
Mode:
PT
Unit: -
Range: 0~9 (0: Disable the second low-frequency
filter)
Data Size: 16bit
Display
Format:
DEC
Settings: The second low-frequency vibration suppression gain. The bigger value
it is, the better the position response will be. However, if the value is set
too big, the motor will not be able to smoothly operate. It is suggested
to set the value to 1.
P1-31 Reserved (Do Not Use)
Address: 013EH
013FH
P1-32 LSTP
Motor Stop Mode Selection
Address: 0140H
0141H
Operation
Interface:
Keypad/Software Communication
Related Section: N/A
Default: 0
Control
Mode:
ALL
Unit: -
Range: 0 ~ 20
Data Size: 16-bit
Display
Format:
Hexadecimal
Settings:
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.