ASDA-B2 Chapter 9 Troubleshooting
Revision September 2013 9-13
Display Fault Name Clearing Method
Serial communication error
Turn ARST (DI signal) ON to clear the fault.
This fault message can also be removed
automatically after the communication is
normal.
Serial communication time
out
Turn ARST (DI signal) ON to clear the fault
or restart the servo drive.
Reserved This fault message cannot be cleared.
Input power phase loss
Turn ARST (DI signal) ON to clear the fault.
This fault message can be removed
automatically after input power phase lost
problem is solved.
Pre-overload warning
Turn ARST (DI signal) ON to clear the fault
or restart the servo drive.
Encoder initial magnetic
field error
This fault message can be removed by
restarting the servo drive.
Encoder internal error
This fault message can be removed by
restarting the servo drive.
Encoder data error
This fault message can be removed by
restarting the servo drive.
Motor internal error
This fault message can be removed by
restarting the servo drive.
Motor internal error
This fault message can be removed by
restarting the servo drive.
Motor internal error
This fault message can be removed by
restarting the servo drive.
Motor protection error
Turn ARST (DI signal) ON to clear the fault.
U,V,W, GND wiring error
This fault message can be removed by
restarting the servo drive.
Motor temperature error
This fault message can be removed by
restarting the servo drive.
Excessive encoder output
error
Turn ARST (DI signal) ON to clear the fault.
Motor temperature warning
This fault message can be removed after
temperature drops to normal degree.
DSP firmware upgrade
This fault message can be removed after
setting P2-08 to 30 first, and then 28 next
and restarting the servo drive.
VARITEL INGENIERIA ELECTRONICA S.A.
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
To Next Page
Loading...
Need help?
General
