Desoutter CVIC - Self-Contained MODCVIC Control Module; MULTICVIC System

6159932010-09
10 / 60
English
CVIC - MODCVIC - MULTICVIC
Main differences between versions LH
Characteristics of the phases:
Search sequence 
Approach 
Run down speed 
Final speed phase 
Action on NOK 
Run Reverse 
Jump to another phase 
Prevailing Torque 
Synchronisation phase 
Tightening strategies:
Torque 
Torque with angle monitoring 
Angle with torque monitoring 
Number of stored results 0 100
2 - Self-contained MODCVIC Control Module
The MODCVIC is the rackable version of the CVIC controller.
Two models are available: MODCVIC-2 and MODCVIC-4 and two versions: «L» and «H».
Without keyboard or display, the MODCVIC must be connected to a PC, temporarily for programming, data transfer and
retrieval of tightening results and permanently to display its real time operation.
The CVIS/CVICPC 2000 software (P.N. 6159275210) is used to program the MODCVIC, whether in point-to-point or in
network connection.
As many as 32 MODCVICs can be networked to the PC.
The MODCVIC can be connected to only one serial port:
- either to the serial printer to print the tightening results in order of occurrence and simultaneously to the bar code reader.
- either to the PC.
The PLC is connected via the relay Inputs/Outputs.
3 - MULTICVIC system
The MULTICVIC is a synchronous multi-spindle machine.
It consists of:
- 1 to 32 MODCVIC slave modules (version H only).
- a CPUCVIC module which controls all the MODCVICs and provides an interface with the external peripherals (PC,
PLC, bar code reader, etc.).
The MULTICVIC system is programmed by means of the CVIPC2000 software, P.N. 6159275220 (see manual 6159932080).