Desoutter CVIC - Setting the Date and Time; Programming the Tightening Cycles

6159932010-09
20 / 60
English
CVIC - MODCVIC - MULTICVIC
2.5 - Setting the Date and Time
- Menu: MAIN\SERVICE\DATE.
- Allows you to select the format: (DD/MM/YY, MM/DD/YY, YY/MM/DD).
- Setting the date.
- Setting the time.
2.6 - Selecting the controller mode
Enter the station menu and select the mode according to the tool you want the controller to run:
- If ECPHT tools are used, select the ECPHT mode.
- Otherwise, select the normal mode.
2.7 - Programming the Tightening Cycles
Overview of the various tightening cycles:
The controller allows you to have access to various programming levels depending on your knowledge in the field
of fastening:
- Learning
After entering the tightening torque, a guided sequence of tightenings allows the controller to learn the
characteristics of the joint to be achieved.
- Quick cycles
After entering and validating the tightening torque and a maximum tightening angle (optional), the other
parameters are automatically set by the controller to default values which comply with most applications.
- Cycles
In this mode, you can program all the parameters manually (speed, acceleration, run down speed torque, torque
tolerances). You can change all the parameters automatically set in the previous 2 programming modes.
For further details, refer to section «Programming the Cycles».
Section 5 - Programming the Version «L» Controller.
Section 6 - Programming the Version «H» Controller.
ECPHT