Desoutter CVIC - BAR CODE Menu; CONTROLLER Menu

6159932010-09
39 / 60
English
CVIC - MODCVIC - MULTICVIC
3.7.3 - «BAR CODE» Menu
The bar code reader allows you to automatically select one of the cycles previously programmed in the
controller. To enable the bar code reader, you need to do the following:
- declare the source of selection of the cycles as being the bar code.
- configure the serial link:
- bar code function.
- Baud rate: 9,600 bauds.
- 8 data bits.
- 1 stop bit.
- no parity.
- set up the table of selection of the cycles according to the bar code numbers, which can be done only
with the CVIPC2000 software.
As the bar code is read by the controller, it can perform one of the following actions:
No action —> no action is performed.
- Reset —> reading the code leads to an action which is identical to the Reset action.
- Reset on NCYCOK —> reading the code leads to a Reset when the programmed number of cycles OK is
reached
3.8 - «CONTROLLER» Menu
Displays the software version of the servodrive and the controller, the serial number and the manufacturing date
of the controller.
It is possible to insert different comments.
It is possible to program the «Ergo-stop» feature (no impact in ECPHT mode).
ECPHT