Desoutter CVIC - PARAMETERS Menu; SPINDLE Menu; CYCLES Menu; Introduction

6159932010-09
26 / 60
English
CVIC - MODCVIC - MULTICVIC
3 - «PARAMETERS» Menu
The «PARAMETERS» menu allows you to:
- display the tool features «SPINDLE» menu
- change the programming of a cycle in detail «CYCLES» menu
- quickly program a cycle «QUICK CYCLES» menu
- determine the best programming «LEARNING» menu
- dedicate the application «STATION» menu
- program the serial port, the report output, the bar code «PERIPHERALS» Menu
- Program a comment, Bolt number «CONTROLLER» menu
3.1 - «SPINDLE» Menu
This menu displays the features of the controller and the features read in the tool memory.
The data cannot be changed.
3.2 - «CYCLES» Menu
3.2.1 - Introduction
This menu allows you to change or create the programming of the cycles.
A tightening cycle consists of a sequence of phases run consecutively. Each phase is defined by main
parameters and tightening instructions according to the selected type of tightening and motor settings.
Nombre possible de phases version CVIC H... 15
The various phases available in a cycle are:
Search sequence-------------------- S
Run down speed -------------------- D
Final speed -------------------------- F
Run reverse-------------------------- R
Act. on NOK ------------------------- V
Jump ---------------------------------- J
Prevail. Torque --------------------- T
Synchr. waiting --------------------- W
Angle rundown---------------------- d
Empty phase
The procedure for programming the cycle can be broken down as follows:
- Selecting the cycle.
- Selecting and sequencing the phases.
- Programming the parameters of each phase.
- Selecting an Action on NOK or not.
- Entering a comment.
- Programming the Number of cycles OK.
Important: the «0» cycle is a special cycle as it is integrated in the tool memory.
It can include 3 phases: «Angle rundown», «Run down speed» and «Final speed».
When connecting the tool, the «0» cycle is selected by the controller if no other cycle input is positioned
at 1.
In this way, the tool can be connected and can run its cycle on any controller without new programming.
3.2.2 - Selecting the Cycle
Menu: MAIN\PARAMETERS\CYCLES.
The list of the cycles already programmed is displayed. Select a number and press to validate.