DEV 2190 - 1 set IP address; 2 set netmask; 3 set gateway; Maintenance of the Product

User Manual DEV 2190
 Copyright DEV Systemtechnik GmbH 2009-2017 37
4.4.2.2.2 1 set IP address
This choice is used to change the IP address of the device:
(...)
your choice > 1<CR>
Current IP address is 192.168.0.225
Enter IP address ('NONE' to clear) >
To change the current IP address type in a different valid address; to clear the
address type in "NONE<CR>"; and just entering <CR> maintains the current setting:
Enter IP address ('NONE' to clear) ><CR>
unchanged
4.4.2.2.3 2 set netmask
This choice is used to change the netmask of the device:
(...)
your choice > 2<CR>
Current netmask is 255.255.0.0
Enter netmask ('NONE' to clear) >
To change the current netmask type in a different valid entry; to clear it type in
"NONE<CR>"; and just entering <CR> maintains the current setting.
4.4.2.2.4 3 set gateway
This choice is used to change the gateway address of the device:
(...)
your choice > 3<CR>
Current gateway is 192.168.0.99
Enter gateway ('NONE' to clear) >
To change the current gateway address type in a different valid address; to clear
the address type in "NONE<CR>"; and just entering <CR> maintains the current setting.
4.5 Maintenance of the Product
The product is almost maintenance-free.
Only the filter of the fan & monitoring module requires a little periodical
maintenance (for the spare part number, please refer to chapter 9):
 Every 3 months: Check the filter and replace it if it is dusty.
 Every 6 months: Replace the filter.
Cleaning of the surface of the chassis should be done carefully with a dry lint-free
cloth.