User Manual DEV 2190
Copyright DEV Systemtechnik GmbH 2009-2017 75
5.5.4.3.5.3 .application.switchGroupTable.switchGroupEntry.swMainRfStatus
OID: .1.3.6.1.4.1.21035.41.2.5.1.3.x
Syntax: INTEGER {ok (1), notok (2), notapplicable (3)}
Access: read-only
Description: The RF signal status for the main ports of the switch units being
member of the corresponding switch group.
Not applicable for this type of device, since the .switchGroupTable
is not available.
5.5.4.3.5.4 .application.switchGroupTable.switchGroupEntry.swRedundancyRfStatus
OID: .1.3.6.1.4.1.21035.41.2.5.1.4.x
Syntax: INTEGER {ok (1), notok (2), notapplicable (3)}
Access: read-only
Description: The RF signal status for the redundancy ports of the switch units
being member of the corresponding switch group.
Not applicable for this type of device, since the .switchGroupTable
is not available.
5.5.4.3.6 .application.numberOfSwitchUnits
OID: .1.3.6.1.4.1.21035.41.2.6.0
Syntax: INTEGER32
Access: read-only
Description: The number of switch units within the device.
For a device with applied redundant amplifier options a value in the
range "1"…"5" can be returned; otherwise (i.e. for a device without
applied redundancy switching functionality) "0" is returned.
Note:
This value is used to determine the maximum index of the following table:
5.5.4.3.7 .application.switchUnitTable
The .switchUnitTable is not available if .numberOfSwitchUnits (please refer to
chapter 5.5.4.3.6) is "0". Only for a device equipped with redundancy switching
functionality a value different from "0" is returned for .numberOfSwitchUnits, thus
a corresponding number of entries per .switchUnitTable OID. With this table the
switching status of a switch unit (here: redundancy unit) can be checked or can be
altered using .swPosition (chapter 5.5.4.3.7.4). Additionally via .swMembers
(chapter 5.5.4.3.7.3) the assignment is stated which port of the .portTable is
member of the related switch unit.
5.5.4.3.7.1 .application.switchUnitTable.switchUnitEntry.swIndex
OID: .1.3.6.1.4.1.21035.41.2.7.1.1.x
Syntax: INTEGER32 (1..64)
Access: not-accessible
Description: A unique value for each table entry ranging between "1" and the
number of entries (defined by .numberOfSwitchUnits, please refer
to chapter 5.5.4.3.6).
To Next Page
Loading...