DEV 2190 - Feature Setup; Recording

User Manual DEV 2190
60  Copyright DEV Systemtechnik GmbH 2009-2017
Note:
 The strings "System Name" and "System Location" are part of standard SNMP
functionality and are limited to 40 characters, each. The number of visible
characters in the text fields is limited by the field size.
 As mentioned, the strings "System Name" and "System Location" are also
displayed in the Start Screen of the Web Interface (chapter 5.4.1).
5.4.7.3 Feature Setup
The Feature Setup menu item on the left side of the Setup Tab provides access for
users with "admin" permission to the device specific setup entries, i.e. to the
Recording entry and to the Auto Mode entry for devices with applied Option 22.
5.4.7.3.1 Recording
The Recording entry permits the configuration of the interval for the signal
recording functionality; please refer to chapter 5.4.6.
Via the "Recording Interval" drop down list the interval for the regular data capture
can be selected. After an entry was picked, the "Resulting Recording Duration" is
displayed in the line below. The following choices are available:
Recording Interval
Resulting Recording Duration
10 Seconds
2 Days
30 Seconds
6 Days
60 Seconds
12 Days
Note:
 After clicking on the button with a different recording interval
selected than the currently applied setting all stored recording data is deleted
instantaneously; the recording starts with the new recording interval setting!
 The default recording interval setting is 10 seconds; after a Restore Factory
Defaults (chapter 5.4.7.4.1), this setting is applied as well.