Digi Connect Series

Configurethedeviceusing theweb interface System Configuration
Digi Connect Family and ConnectPort TSFamily
100
n
Send SNMP trap to the following destination when alarm occurs: Specifies whether to
send the alarm as an SNMPtrap. To send alarms as SNMPtraps, you must set the Alarm Type
to snmptrap and specify the IPaddressof the destination for the SNMPtrapsin the SNMP
settings (Configuration > System > Simple Network Management Protocol). See Simple
Network Management Protocol (SNMP) Settings. That destination IPaddressappears below
the “Send alarm to SNMPdestination” check box. You can also specify a secondary or backup
SNMPdestination.
To configure an alarm notification to be sent as both an email message and an SNMPtrap:
1. Select both Send E-Mail and Send SNMP trap check boxes.
2. Click Apply to apply changesto alarm settingsand return to the Alarms Configuration page.
Configure alarm conditions
To configure an alarm:
1. Select Configuration >Alarms.
2. To enable or disable an alarm, select or clear the Enable check box next to the alarm.
3. Click thealarm under the Alarm column that you want to configure.
4. Configure the fieldsin the following sections:
n
Alarm Conditions: These condition specify the conditions on which the alarm isbased,
such as serial data pattern matching or data usage.
n
Alarm Destinations: These conditionsspecify how the alarm issent, either as an email
message or an SNMPtrap, or both, and where the alarm issent.
5. Click Apply to saveyour changes.
System Configuration
Usethe System Configuration page to configure device identity and description information, date and
time settings, and settingsfor SimpleNetwork Management Protocol (SNMP).
Device Identity Settings
Usethe Device Identity Settingspage to create a description of the Digi Connect and ConnectPort TS
Family product’sname, contact, and location. You can use thisinformation to identify a specific Digi
device product when working with a large number of devicesin multiple locations.
n
Description: The network name assigned to the Digi device.
n
Contact: The SNMPcontact person (often thenetwork administrator).
n
Location: Atext description of the physical location of theDigi device.
n
Device ID: Atext description of the device IDused to identify the device (for example, MACor
IP address).