Digi Connect Series

SNMPdevice monitoring capabilities Download a Digi MIB
Digi Connect Family and ConnectPort TSFamily
142
Download a Digi MIB
To download a Digi MIB:
1. Locate the support page for your product:
2. Under Product Support, click the Utilitiestab.
3. Locate the MIByou want to view under General Diagnostics, Utilities, and MIBs.
Supported SNMP traps
You can enable or disable SNMPtraps. Supported SNMPtraps include:
n
Authentication failure
n
Login
n
Cold start
n
Link up
n
Alarmsissued in the form of SNMPtraps
All products support MIBsfor serial alarms/login traps/RFC1215.
Products with the geofencing/GPSfeature support MIBs for geofencing.
Products with mobile/cellular capability support MIBs for mobile alarms.
From the web interface, you can enable/disable traps at Configuration >System > SNMP >
Enable Simple Network Management Protocol (SNMP) traps.
You can configure alarmsat Configuration >Alarms>Alarm Conditions> Alarm n>
Alarm Destinations> Send SNMP trap to following destination when alarm occurs.