Configureand managethedeviceusing theDigi Connect and ConnectPort
TSFamily command lineinterface
Management through the
command lineinterface
Digi Connect Family and ConnectPort TSFamily
134
n
TCPstatistics. The info tcp command displaysthe following information:
l
Thenumber of segmentsreceived or sent
l
Thenumber of active and passive opens
l
Thenumber of bad segments received
l
Thenumber of failed connection attempts
l
Thenumber of segmentsretransmitted
l
Thenumber of established connectionsthat werereset
n
UDPstatistics. The info udp command displays the following information:
l
Thenumber of datagramsreceived or sent
l
Thenumber of bad datagramsreceived
l
Thenumber of received datagrams that were discarded because the specified port was
invalid
n
Wirelessstatistics. The info wlan command displaysdetailed statistics for wireless devices
that may aid in troubleshooting network communication problemswith a wireless network.
newpass
Usethe newpasscommand to issue a new password to a user.
ping
Usethe ping command to test whether a host or other device isactive and reachable.
reconnect
Usethe reconnect command to reestablish a connection opened by a connect, rlogin, or telnet
command. By default, the reconnect command reestablishesthe connection to thelast active
session.
rlogin
Usethe rlogin command to sign in to a remote system.
send
Usethe send command to send a telnet control command, such as break, abort output, are you
there, escape, or interrupt process, to the last active telnet session.
send mode
Usethe send mode command to configure thetelnet control commands. For example, send telnet
control command to last active telnet session or set telnet operating options.
set alarm
Usethe set alarm command to display alarm settings, including conditionsthat trigger alarms, and
how alarms are sent. You can configure alarmsto besent aseither an email message, an SNMPtrap,
To Next Page
Loading...
Need help?
General
