Configureand managethedeviceusing theDigi Connect and ConnectPort
TSFamily command lineinterface
Management through the
command lineinterface
Digi Connect Family and ConnectPort TSFamily
135
or both. You can configure the alarmsas needed.
set autoconnect
Usethe set autoconnect command to configure the autoconnection behaviors for serial port
connections.
set buffer and display buffers
Usethe set buffer command to configure buffering parameters on a port and display the current port
buffer configuration. The display bufferscommand displaysthe contentsof a port buffer, or transfers
the port-buffer contents to a server running Trivial File Transfer Protocol (TFTP).
set forward
Usethe set forward command to configure IPforwarding.
set gpio
Usethe set gpio to display current GPIOpin settings. You can reconfigure the pin settings as needed.
set group
Usethe set group command to configure create, establish, update, or remove group attributes.
set host
Usethe set host command to configure the host name for the Digi device.
set mgmtconnection
Usethe set mgmtnetwork command to configure the Remote Manager connection settings.
set mgmtglobal
Usethe set mgmtglobal command to configure the Remote Manager global settings.
set mgmtnetwork
Usethe set mgmtnetwork command to configure the Remote Manager network settings.
set network
Usethe set network command to configure the network options.
set permissions
Usethe set permissionscommand to configure the user permissions for variousservices and
command-line interface commands.
To Next Page
Loading...
