Digi Connect Series - Close; Connect; Display

Configureand managethedeviceusing theDigi Connect and ConnectPort
TSFamily command lineinterface
Management through the
command lineinterface
Digi Connect Family and ConnectPort TSFamily
132
n
set mgmtnetwork
n
set network
n
set permissions
n
set pmodem
n
set pppoutbound
n
set profiles
n
set realport
n
set rtstoggle
n
set serial
n
set service
n
set snmp
n
set system
n
set tcpserial
n
set udpserial
n
set user
n
set wlan
close
Usethe close command to close active sessionsthat wereopened by connect, rlogin, and telnet
commands.
connect
Usethe connect command to establish a connection with a serial port.
display
Usethe display commandsto display real-timeinformation about a device, such as:
n
General product information, including the product name, MACaddress, boot, post, and
firmware versions, memory usage, utilization, and uptime, or the amount of time since the
device was booted (display device).
n
Active interfaces on the system. These includethe web interface, command line interface,
Point-to-Point Protocol (PPP), and Ethernet interface, and their status, such as Closed or
Connected (display netdevice).
n
GPIOsignals (display gpio).
n
Logged serial data (display logging/).
n
Memory usage information (display memory).
n
Serial modem signals (display serial).
n
General status of the socketsresource (display sockets).