Digi Connect Series User Manual

Get started with Digi Connect and ConnectPort TS
Family products
ConnectPort TS8/16: Verify thecomponentsand connect
the hardware
Digi Connect Family and ConnectPort TSFamily
25
Pin positions
Note *Use the Altpin setting to swap these two signals: DSRand DCD. NOTE: Altpin setting is only
applicable in EIA-232 mode.
Pin # on 10-wire
connector
Pin # on 8-wire
connector
EIA-23 MEI products only
EIA-422/485 full-
duplex
EIA-485
half-duplex
1 RI TxD- No
connection
2 1 DSR* RxD- DATA-
3 2 RTS RTS+ No
connection
4 3 CGND CGND CGND
5 4 TxD TXD+ No
connection
6 5 RxD RxD+ DATA+
7 6 SGND SGND SGND
8 7 CTS CTS+ No
connection
9 8 DTR RTS- No
connection
10 DCD* CTS-
Configure the ConnectPort TS serial ports
This section explainshow to configure your ConnectPort TSdevice for basic serial port connectivity.
For more detailed information, see Configure the device using the web interface.
Use the Digi Discovery Utility to find devices
You can use the Digi Discovery Utility to discover devices present on a network. You can select a
device from the list, and then configure the serial ports.
See Use Digi Device Discovery utility to sign in to theweb interface.
Configure serial ports
You can configure serial port settingsusing port profiles. Port profiles are a defined set of serial port
parameters for a particular use. For information about which port profile to select, see Select Port
Profile.
Note Digi recommendsthe RealPort port profile. If you want to manage your serial portswith Digi's
RealPort software, download the RealPort software.

Digi Connect Series Specifications

General

Brand	Digi
Model	Connect Series
Category	Network Router
Language	English